Bodybuilding Steroids Oil Testosterone Acetate 100mg/ml
For men, the recommended dosageis 250 – 1000 mg per week, and is not recommended for women use. The cycle can last from 8-12 weeks. These doses are sufficient to achieve high results, both the strength and mass increase.
Testosterone Acetate is an Androgen, commonly used for bodybuilding, physically maintaining and promoting the development of masculinity and sexual organs. It is also used to treat women with breast cancer, ovarian cancer, uterine fibroids, such as multiple myeloma and renal cell carcinoma.
1. Before using this medicine, tell your doctor about any disease, especially prostate cancer or breast cancer (male), liver, heart, kidney disease, allergies, and enlarged prostate cancer. High – dose, long – term use of male hormones, liver cancer;
2. This medicine can not be used during pregnancy. If you are pregnant or think you may be pregnant, immediately notify your doctor. Breastfeeding at the same time, should avoid using this drug;
3. Women should monitor masculine signs such as deepening of sound, beard, acne, irregular menstruation, or clitoral enlargement. If any of these occurs, consult your doctor in a timely manner;
4. Children should be very cautious, because the drug may have adverse effects on child development. Older men use this drug, there is prostate enlargement or prostate cancer risk.
Equipment Required to make powders into oils
Sterile (Syringe) Filters (0.22um Whatman filter)
Needles / Syringes
Organic Filtration Membrane
The Way to Filter Steroid Oil
Attach 22 guage needle to the whatman syringe filter
Swab the top of the vial with alcohol wipes to sterilize it
Insert the 20guage syringe filtered needle into the septum of the vial (the rubber piece)
Insert the second needle tip into the septum to vent the pressure that will build from injecting the solution into the vial
Draw up the warmed solution. Having it warmed will speed up the process and make it easier to filter
Attach the barrel of the syringe to the whatman syringe filter. push the solution through the whatman syringe filter into the sterile vial. Use constant pressure. It will only trickle. Be sure not to apply immense pressure as that will split the syringe filter and you will have a mess everywhere
Detach the syringe barrel from the whatman syringe filter and draw up another 10mls of your steroid solution. Reattach to the syringe filter and filter it into the new sterile vial. .If using 10ml vials, Just repeat steps 9 thru 12 filtering 10mls of the solution in each of the vials
Your choice as to which size vial you use. You will end up with either One 40ml vial or Two 20ml vials or Four 10mls vials at 100mg/ml